domingo, abril 14, 2019

Bypassing USB Power Port on My Raspberry Pi Model B+ || power on raspberry 3 solder pp1 without micro usb

https://blog.shahada.abubakar.net/post/bypassing-usb-power-port-on-my-raspberry-pi-model-b?


With a Raspberry Pi 3. On this unit I used PP2 (Positive) and PP3 (negative), which according to the schematic here shows it as being located before the reverse protection diode. You can also use PP5 for negative but I found that a bit too close to PP1. Of course, it's best to cover the whole thing with hot-melt glue to minimize strain on the wires.


Nenhum comentário: